Q-CLIK
Watertight fitting for entryway in and out of QTL housing
There are four different sizes of machine screw threaded Q-CLIKs available: 0.50”, 0.75”, 1.00”, and 1.25”. Additionally, there are two sizes of national pipe taper: 0.50” and 0.75”. The design of the Q-CLIK enables easy tightening or loosening of the fitting using a raised wing-nut. There is an audible “click” when the fitting is in place, which is where the name was derived. The Q-CLIK comes with rubber washers to go inside and outside of the housing for the additional security of a watertight seal.
The Q-CLIK inserts allow the installer the ease of plug-and-go with different pre-cut slots for different-sized wire. The 0.50” insert has two variations, the 0.75” has seven variations, the 1.00” has three variations, and the 1.25” has three variations. The photos here give a better understanding of these inserts.
Technical Information
Environment | Indoor (Dry), Outdoor (Wet) |